Abstract: Vertical drilling machine is a deep hole drilling can be, good stability, suitable for batch processing products machinery and equipment. Applied in the practical application is very wide. During operation the need to pay attention to safety, must be in strict accordance with the relevant regulations.
Vertical drilling machine applied in the practical application is very wide, during operation the need to pay attention to safety, must be in strict accordance with the relevant regulations. The following is the multi-axis drilling machine vertical drilling handling precautions:
1, the operator used must strictly comply with the maintenance equipment requirements. Overload is strictly prohibited to use the device.
2, machine tool variable speeds must stop to proceed. Prohibited on-stream variable speed, when drilling deep holes to pour crumbs, work can’t leave the machine tool.
3, parking more than eight hours again to start the equipment, should first low speed to open drilling machine and then idle for 3-5 minutes, confirm each part in good condition, normally after power off and start work.
4, work must be properly installed in the tool, drill bushing set to conform to the standard, conical surface must be clean no scratches, must be properly installed firmly mount card on the workbench, Drill hole must be in the low surface mat cushion block, Do not use motorized infeed, must put the control nut pushed to the inside.
5, when unloading Drill fixture using standard wedge and copper hammer gently tap, are not allowed to use anything else Cookin. When the drill bit has long iron filings, want to stop to clear. Prohibit the use winds blowing or blowing through your mouth, use brushes and hook cleared. When the drill bit has long iron filings, want to stop to clear. Prohibit use winds blowing or blowing through your mouth, want to use brushes and hook to clear.
6, work must regularly check equipment operation condition and lubrication system, such as operation and poor lubrication, should stop using the equipment.
7, work should be strictly in accordance with the bearings on the product nameplate calibration temperature operations, to avoid danger.
8, before driving, must be carefully checked in accordance with the tour check point, and lubrication in accordance with the lubrication chart. Check drilling machine lubrication parts in good condition, Cooling system whether normal, rocker arm whether in zero position, operating handle electric control switch whether in the off position, drill bits whether clamped securely, protective equipment whether intact and reliable, can be carried out after all inspection to normal operation.
9, after work shall the hand shank placed in non- working position, workbench down to the lowest position, and cut off the power supply. Cleaning equipment and on-site health and civilized. The equipment surfaces cooling water to wipe clean.
Drill machine handling precautions, Multi-axis drilling machine, Vertical drilling machine matters, Vertical drilling machine operation