Power head also calls the dynamic cutter holder, is installed on the power tool turret, is driven by servo motor. This kind of cutter holder normally used in car milling compound machine, there are a few can be used in the driving force of knife tower on the machining center.
Taizhou purros machinery co., LTD., specializing in the production and sales of drilling power head, drilling power head, tapping head, servo tapping machine, automatic drilling machine, bench drill, machinery, hydraulic damper, multi-axis device, power head jig, slide, etc. Products are exported to the americas, Australia and other countries and regions, favored by users of praise.
Horizontal milling power head application is very extensive, but it can be used correctly. First turn on the milling head on milling card (to carry) (no one refers to the wide tooth position), a hand took where milling head didn’t tooth, and the milling head milling card on milling head. Cases with one hand to twist the nut (only a little, don’t let the hair fall), until the milling card not to drop down; Then take to wash hands to hold the milling head column next round button, patients with one hand to twist the nut until twist, model right. Don’t be too hard and be careful hand was scratched!